Obtaining a Horizontal Panoramic Image in a High-Power Rocket after Landing

Kathryn Elizabeth Lenz, David A. Juckem, Eric S. McDaniel, Jens K. Carter, Shawn R. Schumacher

Abstract


During the 2017-2018 Collegiate Rocket Launch (CRL) competition, teams were required to design and construct a high-power rocket meeting certain design criteria. The goals for the 2018 competition were that it would complete a safe flight, reaching as close as possible to the target apogee height of 3,000 feet, as well as take a 360° horizontal image of the surrounding landscape after landing. The UW-Fox Valley team, the Rocketeers, designed a three-inch diameter, thin-walled fiberglass airframe at a final length of 67 inches that completed three safe flights on competition day. In order to get the 360° image, a Raspberry Pi micro-computer was used with a Pi Camera, which took multiple pictures that would be post-processed and stitched together. To orient the camera correctly, three legs were attached to the bottom of the booster section of rocket which were released at the first ejection after apogee. These legs were designed to orient the booster section to land upright. The camera module, located at the top of the booster, would then take multiple pictures of the surrounding landscape.


Keywords


Rocket; Raspberry Pi; Competition

Full Text:

PDF

References


Apogee Components. RockSim v9, retrieved from , 2018.

Eggtimer Rocketry. Eggfinder GPS Tracking System, retrieved from , 2018.

Featherweight Altimeters. Raven III Altimeter, retrieved from , 2018.

Fruity Chutes. Iris Ultra, retrieved from < https://fruitychutes.com/>, 2018.

Madcow Rocketry. 3” Fiberglass DX3, retrieved from , 2018.

Missile Works. RRC# Altimeter System, retrieved from . 2018.

Raspberry Pi. Camera Module v2, retrieved from , 2018.




DOI: https://doi.org/10.17307/wsc.v1i1.264

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.